Husqvarna FS5000 D Bedienungsanweisung Seite 22

5. Turn the engine start switch to ignition on position
(A).
A
6. If the preheating symbol shows on the display, wait
until it goes off. Refer to
control panel display on page 7 .
7. Turn the engine start switch to engine start position
(B). The engine starts.
B
8. Let the engine operate at idle speed for 2-3 minutes
until the temperature gauge starts to move.
CAUTION: Do not let the engine operate
at low idle speed when the product is not
in operation. Low idle speed increases
the quantity of particles in the engine
and decreases the time between
regenerations.
WARNING: For products without a blade
clutch, the cutting blade starts to rotate
when the engine starts and the gear is
not in neutral. Do not move the product
to the side or out of the work area if the
cutting blade rotates.
To operate the product
1. Start the engine.
22
Warning symbols on the
2. Push the button adjacent to the symbol for the water
safety system. The symbol on the display changes
color to show that the function is engaged.
3. Open the water valve.
4. Push the engine speed button (A). The engine
symbol (C) shows that the speed adjustment knob
(B) adjusts the engine speed.
A
B
5. If the product has a blade clutch, do this procedure:
a) Make sure that the engine speed is not higher
than 1200 rpm.
2
1
3
0 4
14
2
1
3
0 4
12
10 14
5.0
8 18 WORKING HOURS
V
CURRENT: STOP:
0
12
10 14 C
5.0
WORKING HOURS
8 18
V
CURRENT: STOP:
4.00˝ 1.50˝
RPM
< 1200 RPM
180
150 210
1143 - 002 - 08.07.2019
180
150 210
110 250
˚F
4
180
150
110
˚F