Husqvarna FS5000 D Bedienungsanweisung Seite 17

To install a blade guard
1. Lower the blade guard onto the supports (A), (B),
and (C).
A
2. Push the blade guard down until the blade guard
lock (D) engages.
3. Connect the water hose.
All supports are not used for all blade guard dimensions.
• 14 in., 20 in. and 26 in. blade guards are lowered
onto the support (B) only.
• 30 in. blade guard is lowered onto the supports (B)
and (C).
• 36 in. blade guard is lowered onto all supports (A),
(B), and (C).
1143 - 002 - 08.07.2019
D
C
B
To remove the blade guard
1. Disconnect the water hose (A) from the blade guard.
C
A
2. Use the blade shaft wrench to turn the blade guard
lock (B) forward until it stops and disengages.
3. Lift the blade guard at the handle (C).
Product configuration for different blade
dimensions
A product with a 1-speed gearbox operates with 1
specified blade dimension and 1 specified blade guard.
A product with a 3-speed gearbox operates with a
specified range of blade dimensions in 1 specified blade
guard. If you replace the cutting blade with a cutting
blade of a different dimension, it is necessary to change
the configuration of the product.
For a product with a 1-speed gearbox, replace these
parts with parts of the applicable dimension for the new
cutting blade:
• Blade shaft pulleys
• Gearbox pulleys
• Blade shaft flanges
• Belts
• Blade guard
For a product with a 3-speed gearbox it is sufficient to
change the gear if the dimension of the new cutting
blade is in the same dimension range as the replaced
cutting blade. If the dimension range is different, it is
necessary to replace the parts in the list also on a
product with a 3-speed gearbox.
Let your dealer help you to send an order for the parts
that is necessary for your configuration.
B
17