Storage; Possible Faults; Corrective Action - ATIKA HSC 60-400 Originalbetriebsanleitung

Switch off the device before each transport and remove the battery to prevent unintentional startup.
Store unused products with attached protective cover in a dry, locked place out of the reach of children.

Before extended storage, please observe the following to increase the service life of the device and to ensure smooth operation:

Thoroughly clean the device.
−
Oil all moving parts with environmentally compatible oil.
−

For information on "Storage" of the battery and the charger, please refer to the respective "Operating Instructions".
Before each fault elimination:
Switch off device.
−
Wait unitl the cutting tool comes to a stop.
−
Remove the battery.
−
Wear protective gloves.
−

After each fault clearance, put into operation and recheck all security installations.
Fault code
Machine does not start after
switching on
Machine does not work with
full performance
Machine does not cut properly
Machine cuts with interruptions  Switch button on handle defective
Device shuts off on its own
Device does not run quietly,
vibrates strongly
Knives get hot
Motor is running, knives do not
move
Cutting device does not stop
after releasing a switch button
Cutting time with fully charged
battery too short
Operating mode cannot be
selected

In case of further faults or inquiries please contact your local dealer.
20

Storage

Possible faults

Possible Cause
 Lithium ion battery run down
 Lithium-ion battery not engaged correctly
 Lithium ion battery defective
 Switch button on handle defective
 Internal fault
 Lithium ion battery run down
 Lithium ion battery defective
 Cutting tool blunt / worn
 Missing lubrication → friction
 Cutting device dirty
 Screw joints of the cutting devices are loose
 Internal fault
 Lithium ion batteries too hot (45 °C)
 Battery charge too low
 Cutting device damaged
 Fastening of cutting device has come loose
 Missing lubrication → friction
 Knife edges became blunt.
 Blade has notches
 Knives are blocking
 Internal fault
 Quick-stop for cutting device defective
 Switch button on handle
 Missing lubrication → friction
 Cutting device dirty
 Rechargeable battery is low
 Battery service life exhausted
 Economy / normal mode toggle buttons
defective

Corrective action

 Charge the lithium ion battery
 Insert the lithium-ion battery correctly
 Contact the customer service
 Charge the lithium ion battery
 Contact the customer service
 Sharpen the blades or have them
replaced
 Oil the cutting device
 Clean the cutting device
 Tighten the screw joints
 Contact the customer service
 Allow lithium-ion battery to cool down
 Charge the lithium ion battery
 Contact the customer service
 Oil the cutting device
 Arrange sharpening of knives
 Check blade and have it sharpened
 Remove object
 Contact the customer service
 Contact the customer service
 Oil the cutting device
 Clean the cutting device
 Charging the rechargeable battery
 Replace the rechargeable battery
 Contact the customer service