X85; „ Dynamic Allocation Setting; Booster Heater - STIEBEL ELTRON STE Inbetriebnahme

COmmISSIONING
Controller menu
… …„ Primary heat pump DHW mode
Can only be set when the "System DHW mode" function is acti-
vated.
f Activate or deactivate the function. f
When this function is activated, DHW heating is carried out by the
primary heat pump.
… …„ DHW mode start temp.
f Set the DHW temperature at which DHW heating starts. f
DHW mode stop temp.
… …„
f Set the DHW temperature at which DHW heating stops. f
… …„ Sensor influence
f Set how the influence is shared between the top and bottom f
sensor.
If you set a mid-range value, the top and bottom sensors have the
same amount of influence.
… …„ DHW mode max. runtime
f Set how long the heat pump is to be responsible for DHW f
heating when there is a DHW demand.
When this time has expired, the appliance checks if there is a heat
demand. If there is a heat demand, this demand is processed by
the heat pump.
… …„ Circulation pump min. speed
f Set the minimum output at which the circulation pump f
should run to meet the DHW demand.
… …„ Circulation pump max. speed
f Set the maximum output at which the circulation pump f
should run to meet the DHW demand.
Minimum compressor stage
… …„
f Set the minimum stage at which the heat pump should run to f
meet the DHW demand.
… …„ Maximum compressor stage
f Set the maximum stage at which the heat pump should run f
to meet the DHW demand.
… …„ Pasteurisation mode
f Activate or deactivate the function. f
When the function is activated, the DHW in the DHW cylinder is
heated according to the settings.
… …„ Max. heating phase
f Set the number of days until the pasteurisation program next f
starts up.
www.stiebel-eltron.com
… …„ Pasteurisation mode max. runtime
f Set the duration for which the pasteurisation program is to f
run.
… …„ Pasteurisation mode stop temp.
f Set the temperature which must be reached before the pas- f
teurisation program is terminated.
… „

Dynamic allocation setting

Some connections on the heat pump controller can have other
functions assigned to them. Observe the details in the operating
and installation instructions for the heat pump (chapter "Electrical
connection / Dynamic allocation").
f Set which functions you would like to use on which module. f
If an assignment isn't possible, the selection is shown in red.
… „

Booster heater

… …„ Activate booster heater
… …„ Temporarily deactivate external booster heater
… …„ Outside temperature-dependent
… …„ Outside temperature limit
… …„ Start delay
… …„ Start limit calculated demand
… …„ Stop limit calculated demand
… …„ Heat-up time
… …„ Cooldown time
… …„ Deactivate cooldown time delay
… …„ System flow offset
… …„ Accounting period
… …„ P
… …„ I
… …„ Minimum opening level
… …„ Maximum opening level
Parameter
Feedback, opening level
Activate booster heater
… …„
f Activate or deactivate the function. f
When the function is activated, the booster heater switches on as
the last output stage when there is a heat demand.
Temporarily deactivate external booster heater
… …„
f Activate or deactivate the function. f
… …„ Outside temperature-dependent
f Activate or deactivate the function. f
When this function is activated, the booster heater is activated at
the set outside temperature.
Unit
%
STE | 37