Set A Door Gong - behnke myintercom One Anleitung

Connect the door gongs to the terminals marked
"Gong". Button 1 controls gong 1, button 2 con-
trols gong 2 ... the buttons are numbered in an
ascending order from top to bottom.
Door bell 1
(on site)
Door bell
transformer
(on site)
Important! To enable tamper protection, the
cover needs to be reattached to the housing
after connection!
www.behnke-online.de
Instructions myintercom Plus IP video door intercom

3.4. Set a door gong

It is possible to assign a number of gong sounds
per time the button was pressed. The default
setting will make the gong sound twice when
the button is pressed once (setting 2). Turning
the rotary control on the door intercom's
electronics allows to set this number to values
between 0 and 9. When set to 0, no gong will
sound, but there will be a push notification on
your device.
To turn the rotary control, please remove the
housing cover and turn the dial to the desired
value.
Important! To enable tamper protection, the
cover needs to be reattached to the housing
after connection!
GB
Installation
64