Replacing The Blade; Waste Disposal; Technical Data - EINHELL New Generation EM 1650 Bedienungsanleitung

Anl EM 1650_SPK1:Anl EM 1650_SPK1
GB
motor cable is not jammed. Keeping your hand
mower in good condition not only ensures a
long lifespan and high performance, but also
enables the machine to thoroughly cut your
grass with minimal effort. For best results,
clean the lawn mower with a brush or rag. Do
not use any solvents or water to remove dirt.
The cutting components - i.e. the knife cage
and lower knife blade - are subjected to more
wear and tear than any other component of the
unit. Therefore, routinely check the condition of
the blade and make sure that it is tightly
fastened. If the blade is completely worn out, it
must be immediately replaced or ground sharp
again. An excessively vibrating mower means
that the blade is not properly balanced or has
become deformed from striking an object. In
this case, the blade must be repaired or
replaced.

11. Replacing the blade

For safety reasons, we recommend having the
blade replaced by an authorized professional.
Important!
Wear work gloves!
Only replace the blade with a genuine Einhell
replacement blade, as this will ensure top
performance and safety under all conditions.
Carry out the following steps to change the
blade:
Undo the fastening screw (fig 13).
Remove the blade and replace with a new
one.
When fitting the blade, make sure it is
installed in the right direction. The bladeʼs
air vanes must jut into the motor
compartment (see Fig. 14). The dome
mounts must be aligned with the punch
holes in the blade (see Fig. 14).
Then retighten the fastening screw with the
universal wrench. The tightening torque
should be approx. 25 Nm.
24
19.10.2006 10:31 Uhr Seite 24
At the end of the season, perform a general
inspection of the lawn mower and remove any
grass and dirt which may have accumulated.
At the start of each season, ensure that you
check the condition of the blade.
If repairs are necessary, please contact our
customer service center.
Use only original replacement parts.

12. Waste disposal

Important!
The lawn mower and its accessories are made
of various types of material, such as metal and
plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local
council.

13. Technical data

Voltage:
Power input:
Motor speed:
Cutting width:
Cutting height adjustment: 25-75 mm; 10 levels
Volume of catch bag:
L sound pressure level:
pA
L sound power level:
WA
Vibration at the handlebars a
230 V ~ 50 Hz
1600 watts
3000 rpm
42 cm
50 liters
73 dB(A)
95 dB(A)
≤ 2.5 m/s
: 2
hv