Cleaning And Care - GUTMANN Capa EM0701 Bedienungsanleitung

LED 1 blinking: Indicates automatic cool
down period (the hood will automatically
decrease by one power level every 5
minutes until it finally turns off)
LED 2: Power level 1 (lowest motor
speed), press button 2 on the remote
control once
LED 3: Power level 2 (middle motor
speed)
Press button 2 on the remote control
twice
LED 4: Power level 3 (high motor
speed)
Press button 2 on the remote control
three times
LED 5: Intensive level (motor automati-
cally returns to level 3 after 5 minutes)
Press button 3 on the remote control
LED 6: Filter Saturation Indicator
The metal filter must be cleaned when
the red LED lights up (see section on

cleaning and care).

Cleaning and care
Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse.
When cleaning, make sure that no water
penetrates the device.
Regular cleaning of the surface saves
laborious removal of stubborn contami-
nation. Only use conventional deter-
gents or universal cleaning agents suita-
ble for cleaning
aluminium. Never use abrasive cleaning
agents or steel wool. After cleaning the
hood, treat the stainless steel surfaces
with a stainless steel care product.
Painted surfaces should only be cleaned
using a mild detergent solution and a
very soft cloth. Only use a soft damp
cloth to clean the operating panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
stainless steel/
remove any grease deposits from the
accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note:
Caution: Ventilate the kitchen sufficient-
ly, no open flame. Only clean the oper-
ating panel with a soft damp cloth (mild
detergent solution). Do not use stainless
steel cleaners for the sliding switch/
pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean stain-
less steel surfaces with abrasive scour-
ing pads or with cleaning agents con-
taining sand, soda, acid or chloride!
Clean in direction of polish only. We
recommend our stainless steel cleaner
no. 461731. See the enclosed service
booklet for the order address.
Aluminium, varnished and plastic
surfaces:
Use a soft micro fibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.
Metal filter
Removing the filters
Fire hazard! The performance of the
extractor hood is reduced by grease
residues and the fire hazard increases.
To prevent a fire hazard, you must clean
the filters regularly. The grease filters
must be cleaned at the least once a
fortnight. To do this, grip the metal filter
with both hands at the top and bottom
and pull forward until the magnet con-
tact releases. You can now remove the
metal filter.
Cleaning the filters
EN
33