Cleaning And Care; Battery Change - GUTMANN Llano EM 32 Bedienungsanleitung

EN

Cleaning and care

Cleaning the surfaces
Danger due to electric shock! Disconnect
the extractor hood from the power supply
by pulling the plug out of the socket or by
switching off the fuse. During cleaning,
make sure that no water penetrates the de-
vice. Timely cleaning of the surface saves
the later laborious removal of stubborn con-
tamination. Only use conventional deter-
gents or universal cleaning agents for
cleaning suitable
aluminium. Never use abrasive cleaning
agents or steel wool. After cleaning the
hood, treat the stainless steel surfaces with
a stainless steel care product.
Painted surfaces and the control panel
should only be cleaned using a mild deter-
gent solution and a very soft cloth. Do not
use stainless steel cleaners for the sliding
switch/pressure switch.
On hoods fitted with a panel below the filter
(edge extraction), grease deposits occur at
the edge of the panel. These deposits oc-
cur for physical reasons and are due to a
malfunction of the hood. Please clean the
panel underneath the filter regularly to pre-
vent the formation of stubborn residues.
Note: Do not
on plastic surfaces, as dull spots may re-
sult.
Caution: Ensure the kitchen is properly
ventilated. Avoid naked flames.
24
for stainless steel/
use alcohol (spirits)
Remote control battery change:
The battery cover is located on the back of
the remote control. Unscrew the Phillips
screw and lift it with thumb and index finger
until the magnetic contact which holds the
battery cover is released. Now remove the
empty batteries and replace them with the
same type. Replace the battery cover and
screw it tighttention: Dispose of empty bat-
teriet. As properly !
Technical data:
Dimension: 230 x 34 x 10
Battery: 2 pieces Lithium
Type: CR 2032 3V
Range: ~ 2m