Sh-110 Power Cord Selection - Agilent Technologies SH-110 Bedienungshandbuch

Power Cord
Several power cord options are available from your
Agilent dealer. Descriptions of the available power cords
and their ordering numbers are given in Table 2.
For high voltage operation, the pump
NOTE
must be connected to the power supply
using a high voltage IEC-320 type
power cord of at least 10 A capacity.
Table 2 SH-110 Power Cord Selection
Country Power Cord Specification
Europe 10 A / 220-230 VAC, 2.5 m 656494220
Denmark 10 A / 220-230 VAC, 2.5 m 656494225
Switzerland 10 A / 230 VAC, 2.5 m
UK/Ireland 13 A / 230 VAC, 2.5 m
India 10 A / 220-250 VAC, 2.5 m 656494245
Israel 10 A / 230 VAC, 2.5 m
Japan 12 A / 100 VAC, 2.3 m
15 A / 125 VAC, 2.0 m
North
America
10 A / 230 VAC, 2.5 m
Grounding Instructions
This product should be grounded. In the event of an elec-
trical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric cur-
rent. This pump is equipped with a power cord that has a
grounding wire with an appropriate grounding plug. The
plug must be inserted into an outlet that is properly
installed and grounded in accordance with all local codes
and ordinances.
SH-110 Dry Scroll Vacuum Pump
Order
656494235
656494250
656494230
656494240
656458203
656494255
Improper installation of the grounding
DANGER
plug can result in a risk of electrical
shock.
For United States and Canadian instal-
lations:
❑
When this product is configured for
use on a nominal 120 V circuit, it must
be used with a grounding plug that
looks like the plug illustrated in
Figure 4.
❑
If repair or replacement of the
cord or plug is necessary, connect
the grounding wire to the grounding
terminal only.
❑
The grounding wire is insulated and
its outer surface is green. It may or may
not have yellow stripes.
❑
When this product is configured for
use on a nominal 220 V circuit, it must
be used with a factory supplied cord
and plug that permits connection to the
proper electric circuit. See "Electrical
Connections" on page 18 for proper
rating and type of cord set.
Check with a qualified electrician or
WARNING
serviceman if the grounding instructions
are not completely understood, or if
you are in doubt as to whether the
product is properly grounded.
Do not modify the plug provided; if it
does not fit the outlet, have the proper
outlet installed by a qualified electrician.
Connect the product only to an outlet
that has the same configuration as the
plug.
Do not use an adapter with this
product.
19