Before First Use; Daily Use - IKEA Renlig Handbuch

ENGLISH
Spin reduction button

Before first use

1. Ensure that the electrical and water
connections comply with the installation
instructions.
2. Remove any material from the drum.
3. Pour 2 liters of water into the main wash
compartment
drawer in order to activate the ECO
valve.

Daily Use

Loading the laundry
Open the water tap. Connect the mains
plug to the mains socket.
1. Pull the door handle to open the
appliance door.
2. Put the laundry in the drum, one item at
a time.
3. Shake the items before you put them in
the appliance.
Make sure not to put too much laundry in
the drum. Refer to max. loads indicated in
"Programme chart".
4. Close the door.
By pressing this button you can change the spin speed of the se-
lected programme.
The relevant indicator illuminates.
Rinse Hold option
Set this option to prevent the laundry creases. The drum turns
regularly to prevent the laundry creases.
The relevant indicator illuminates.
There is a water in the drum when the programme is
completed. The door stays locked. You must drain the
water to unlock the door. To drain the water refer to
«At the end of the programme».
of the detergent
Select a cotton cycle at the highest
temperature without any laundry in the
appliance, to remove any manufacturing
residue from the drum and tub.
Pour 1/2 a measure of detergent into the
main wash compartment and start the
appliance.
There is a risk of water leakage or damage
to the laundry.
11
Caution!
Make sure
that no
laundry
stays
between
the seal
and the
door.