IKEA Renlig Handbuch Seite 24

ENGLISH
Problem
The appliance
switches off dur-
ing the washing
phase:
The appliance
spinning phase
starts late or does
not start:
There is water on
the floor:
The door does not
open:
Possible cause
The mains supply has been cut off. Wait for the electricity restore.
The electronic unbalance detec-
tion device has cut in because the
laundry is not evenly distributed in
the drum. The laundry is redistrib-
uted by reverse rotation of the
drum. This may happen several
times before the unbalance disap-
pears and normal spinning can re-
sume. If, after 10 minutes, the
laundry is still not evenly distrib-
uted in the drum, the appliance
will not spin.
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any
leaks from one of the inlet hose fit-
tings. It is not always easy to see
this as the water runs down the
hose; check if it is damp.
The drain or inlet hose is dam-
aged.
The programme is still running.
The door lock has not been re-
leased.
There is water in the drum.
Solution
The appliance will start again
from the same interrupted wash-
ing phase.
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
Check the water inlet hose con-
nection.
Replace it with a new one (check
with the Authorised Service Cen-
tre the right spare part number).
Wait the end of washing cycle.
Wait a few minutes before open-
ing the door.
Select drain or spin programme
to empty out the water.
24