IKEA Renlig Handbuch Seite 12

ENGLISH
Measure out detergent and fabric
softener
Close the drawer gently
Setting a programme
1. Turn the programme knob to switch the
appliance on and set the programme:
• The indicator of the button
flashes.
• The display shows the programme
duration.
2. If necessary, change the spin speed or
add available options. When you
activate an option, the indicator of the
set option comes on.
If you set something incorrect, the
display shows the message
.
Pour the detergent
into the main wash
compartment or
in the appropriate
compartment if the
selected programme/
option it requires (see
more details in
"Detergent dispenser
drawer"). To pour the
right quantity of the
detergent, see more
details in "Degrees of
water hardness".
Pour fabric softener
into the compartment
marked (must not
exceed the «MAX»
mark in the drawer).
For the description of each wash
cycle, the compatibility among
the washing programmes and
the options, consult the chapter
«Programmes».
Starting a programme without the delay
start
Press the button
• The indicator of the button
to flash and stays on.
• The programme starts, the door
locks, the indicator
• The programme time decreases with
steps of one minute.
The drain pump can operate for
a short time at the beginning of
the washing cycle.
Starting a programme with the delay start
option
1. Press the button
until the display shows the delay you
want to set. The delay start indicator
comes on.
2. Press the button
• The door is locked and the indicator
is on.
• The appliance starts the countdown.
• When the countdown is completed,
the programme starts automatically.
You can cancel or change the set
of the option before you press
the button
button you can only cancel
the option.
.
stops
is on.
again and again
:
. After pressing the
12