Before Initial Use; Initial Use; Boiling The Water - Silvercrest SWKH 2400 A1 Bedienungsanleitung Und Sicherheitshinweise

6. Before initial use

Remove the SWKH 2400 A1 kettle and all accessories from the packaging and check the
completeness of the delivery. Remove the protective film. Keep the packaging material away from
children and dispose of it in an environmentally-friendly manner.

7. Initial use

Before you prepare water for consumption for the first time, you must first clean the kettle (8) in
order to remove dust and any remnants of the packaging material. Proceed as follows to clean the
kettle:
1. Open the lid (1) by pressing the lid release button (2) and rinse the kettle (8) with clear water.
2. Fill the kettle (8) with drinking water up to the '1.7 l MAX' mark.
3. Close the lid (1) by pressing it down until it snaps into place. Boil the water once (see 'Boiling
the water' section below) and pour it out.
Repeat steps 1–3. The kettle (8) is now clean and disinfected. You can now use the kettle (8).

7.1. Boiling the water

DANGER of electric shock
Keep the base (7) away from water. There is danger of electric shock.
WARNING
Boil the water and pour it away twice before you use the kettle for the first
time (see the previous section on 'Initial use').
WARNING
Always use fresh drinking water. Do not drink water that has been in the
kettle (8) for longer than an hour. Do not reheat water that has cooled
down. Always pour away old water. Otherwise germs may form.
Cable rewind
An integrated cable rewind is located on
the underside of the base (7). You can
adapt the length of the power cable (6) to
the conditions at the location in which you
are using the kettle.
You can minimise the length of the cable
when you are not using the kettle.

Unwind the power cable (6) on the underside of the base (7).
SilverCrest SWKH 2400 A1
English - 29