Initial Use; Boiling Water - Silvercrest SWKS 2400 F2 Bedienungsanleitung

Initial use

Boiling water

SWKS 2400 F2
Downloaded from www.Manualslib.com
WARNING - RISK OF INJURY!
► Always and only use freshly drawn mains water in the kettle! Do not con-
sume any water that is not certified as potable. If you do, you are taking a
risk with your health!
Before starting the appliance up, make certain that ...
– the appliance, plug and power cable are in a serviceable condition
and ...
– all packaging materials have been removed from the appliance.
1) Open the lid by pressing on the release button
2) Fill the appliance with water up to the MAX mark and let it come to a full
boil once – as described in the next section.
3) After it has boiled, pour this water away.
4) Rinse the kettle out with clear water.
5) Refill the appliance with water up to the MAX mark, and then bring it to the
boil. When done, pour this water away also.
6) Rinse the kettle out with clear water.
The appliance is now ready for use.
RISK - ELECTRICAL SHOCK!
► Never place the electrical base
potentially fatal risk!
WARNING - RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has already
stood in the kettle for longer than one hour. Do not reboil water that has cooled
down. Always pour old water away. Microbes could have formed in it!
NOTE
► Always ensure that the ON/OFF switch
the mains plug is unplugged and the appliance is standing on the base
If not, the device could heat up unintendedly as soon as the mains plug is
plugged in again.
manuals search engine
.
close to water – this would be a
is in the "0" position (off) when
.
│
GB 7 ■