Channel Scan; Transmitting And Correct Use Of Microphone; External Sockets; External Loudspeaker - Albrecht AE5290 XL Bedienungsanleitung

•
SCAN appears on the display and the channel scan starts almost immediately by
scanning all the channels down the frequencies.
•
The scan is stopped at each signal worth receiving and you can listen in to the
conversation.
If you leave the set alone it will re-start the scan after about 5 seconds and continue to
search for channels in use.
You can stop the scan at any time by pressing the SCAN button a second time.
• Pressing the transmission button will also automatically stop the scan modus.
As a special function of the AE 5290 XL you can also change the direction in which scanning
takes place:
Press the ∨ button on microphone during the scan or turn the rotary knob slightly to the
•
left: the scan direction will change, i.e. from higher to lower channel numbers.
•
Press the button SCAN longer, about 2 seconds.
• Now the memory channels appear on the display and the scanner will only check the 5
memory channels for activity.
•
With the transmission button (Push To Talk) on the side of the microphone you can switch
between receiving and transmitting:
• Press PTT button to transmit.
The display shows TX .
• Release PTT button again to switch back to receiving.
When the transmission PTT button is depressed, you can speak from a distance of about 5-
10 cm into the microphone. The modulation amplifier of your AE 5290 XL is sensitive enough
and enables you in most cases to speak with even more distance, depending on how loud
your voice is. An automatic regulator ensures that your partner always hears your signal at
the same volume.
It is best to test the best distance from the microphone for yourself with the help of another
station.

External loudspeaker

Depending on the surrounding noise, it can be advisable to hook up an external loudspeaker.
Usual commercial radio loudspeakers with 4-8 ohms impedance and 2-4 W minimum output
can be plugged in.
The cable can be up to 3 metres long. For car loudspeakers, make sure to use a two-pin 3.5
mm jack plug and ensure that none of the loudspeaker connections are attached to the
vehicle chassis.
Stop channel scan
Change direction of scan
Start MEMO scan

Transmitting and correct use of microphone

External sockets

12