Channel Scan - Albrecht ae 5290 xls Anleitung

Programming Memo locations
You can re-programme each of the 5 numbers of the memory positions to any desired
channel (e.g. private channels or club channels):
• Choose when in normal modus the desired channel.
• Press the MEMO button (for around 2 seconds) until a memory position number
(1 to 5) appears next to the channel number and ME appears on the display.
• Using the channel switch choose the desired memory position number (1 to 5).
• Briefly press the MEMO button to save the number. To return to normal modus
turn the channel switch once, or one of the channel selection buttons on the
microphone.
Now the station is saved and will be stored.
Please note that the German channel numbers 41 to 80 can only be
stored and recalled when the country switch is in the position for 80/40
(Germany). Channels 41-80 do not appear in other country settings.
After changing any country settings, the previously stored memory
channels are not reset and remain as before.
Your AE 5290 XL has an automatic channel scan, which can be used for all channels and for
the stored channels.
First choose the mode of operation (normal channel modus or MEMO modus).
Adjust the muting control to the point at which the receiver should open (see also 'Adjusting
squelch').
• Briefly press the button SCAN.
• SCAN appears on the display and the channel scan starts almost immediately by
scanning all the channels down the frequencies.
• The scan is stopped at each signal worth receiving and you can listen in to the
conversation.
If you leave the set alone it will re-start the scan after about 5 seconds and continue to
search for channels in use.
You can stop the scan at any time by pressing the SCAN button a second time.
• Pressing the transmission button will also automatically stop the scan modus.
As a special function of the AE 5290 XLS you can also change the direction in which
scanning takes place:
Press the ∨ button on microphone during the scan or turn the rotary knob slightly to the
•
left: the scan direction will change, i.e. from higher to lower channel numbers.
• Press the button SCAN longer, about 2 seconds.
•
Now the memory channels appear on the display and the scanner will only check the 5
memory channels for activity.

Channel scan

Start channel scan
Stop channel scan
Change direction of scan
Start MEMO scan
11