Channel Scan Operation; Battery Alert; Background Illumination - Albrecht Tectalk Smart XL Bedienungsanleitung

Channel Scan Operation

This feature allows you to monitor all channels automatically for valid
signals. While scanning you can transmit and receive. When a signal is
received, the scan is interrupted and will return to scan mode
approximately 5 seconds after the reception is terminated.
Note: while the SCAN mode is active, the MODE button is disabled.
Please note that the SCAN mode will reduce the overall battery life
since the battery save function cannot be used during scanning.
To enable the channel scan mode:
•
From standby mode momentarily press the Power On/Off Button;
SCAN will appear on the LCD display.
•
The radio will automatically display each channel (1-8) in ascending
order to find an active main channel.
•
When the unit does not find any signals and you want to transmit,
press PTT to return to primary channel operation. The transceiver
will automatically resume scanning approximately 15 seconds after
the communication is completed.
•
If there is no activity and you want to leave the scan mode press
the Power On/Off button momentarily and the unit will return to
normal operation; the SCAN icon (scan) will disappear from the
LCD display.

Battery Alert

When the low battery icon (
recharge the unit or install fresh charged NiMH batteries.

Background illumination

By pressing any buttons, the LCD backlight is turned on the LCD
illumination will be turned off automatically in about 5 seconds after
any final button is pressed.
) blinks steadily on the LCD panel,
11