Inhaltsverzeichnis
Werbung
• ENGLISH •
USING THE CARRYCOT
Handle adjustment [ fig. 1]
Press the buttons at the side and adjust the handle into the new position, release the buttons and check
that the handle is locked in place.
Assembling the hood [ fig. 2 - fig.3]
Line up the pins of the hood and insert them into the slots at the side of the carrycot.
Press downwards, a click indicates the hood has been secured in place.
To remove the hood, press the lower part of the hood securing pin and at the same time remove the
hood from its slot.
Backrest adjustment [ fig. 4, fig.5]
To lift or recline the carrycot backrest, press and adjust the lever into the new position.
Make sure the backrest has been secured correctly in place, in the chosen position.
Rocking system [ fig. 6]
Two supporting feet are located in the base; fold them both out to prevent the rocking movement, open
both of the feet inwards to allow the rocking movement.
Both feet must be folded inwards or opened outwards.
Hood adjustment [ fig. 7]
Lower or lift the hood to achieve the required position.
Ventilation [ fig. 8]
Open the zip or the viewing window, according to the model purchased, to ventilate the inside of the
carrycot.
Internal ventilation
It is possible to adjust internal ventilation by using the lever (A)
Cover [ fig. 9]
Fit the cover on the carrycot using the press fasteners.
Care and maintenance
Periodically inspect your carrycot for worn or damaged parts. If damaged parts are found, replace the
carrycot.
Cover
The fabric parts can be cleaned according to the instructions on the washing label.
Clean the fabric with water, neutral detergent and a sponge.
Never use abrasive products for cleaning or ammonia based products, bleach or turpentine.
Brush the fabric rather than wash it.
Buckle
Food, drink, or other debris may collect inside the harness buckle which can affect proper function.
Wash in warm water until clean. Be sure you can hear an audible click to make sure the buckle is working
properly.
Harness and plastic seat shell
The plastic and metal parts can be cleaned with warm water, a sponge and a neutral detergent.
10
Werbung
Inhaltsverzeichnis
