Batetry Replacement; Notification About Battery Regulation - PeakTech 2715 Bedienungsanleitung

7. Battery Replacement
1. When the low battery symbol "
the six 1.5V 'AA' batteries must be replaced.
2. Turn the device off and remove the test leads.
3. Unsnap the tilt stand from the
rear of the tester.
4. Remove the four Phillips head
screws holding the battery
cover.
5. Remove the battery compartment
cover.
6. Replace the batteries observing
polarity.
7. Affix the rear cover and secure
the screws.
8. Reattach the tilt stand.
8. Notification about the Battery Regulation
The delivery of many devices includes batteries, which for example serve to operate
the remote control. There also could be batteries or accumulators built into the device
itself. In connection with the sale of these batteries or accumulators, we are obliged
under the Battery Regulations to notify our customers of the following:
Please dispose of old batteries at a council collection point or return them to a local
shop at no cost. The disposal in domestic refuse is strictly forbidden according to the
Battery Regulations. You can return used batteries obtained from us at no charge at
the address on the last side in this manual or by posting with sufficient stamps.
Contaminated batteries shall be marked with a symbol consisting of a crossed-out
refuse bin and the chemical symbol (Cd, Hg or Pb) of the heavy metal which is
responsible for the classification as pollutant:
1. "Cd" means cadmium.
2. "Hg" means mercury.
3. "Pb" stands for lead.
" appears on the LCD,
18