Battery Replacement - PeakTech 5200 Bedienungsanleitung

For material moisture measurement mode (
If the reading is < 0,2%, all LED's without indication
If the reading is > 0,2% and is < 0,7%, the green LED will
flash
If the reading is > 0,7% and is < 0,9%, the yellow LED will
flash
If the reading is > 0,9%, the red LED will flash
3.) To lock the present reading on the display, press the key.
The display stops updating and the symbol "
Auto Power Off
If the device is not used or if the screen does not change,
automatically turns off after 15 seconds.
Backlight switch:
- Power on the instrument
- Press the "ON/SET" button again
After 15 seconds the backlight turns off automatically.

7. Battery Replacement

If the sign "BAT" appears on the LCD display, it indicates that
the battery should be replaced. Remove screws on the back
cover and open the case. Replace the exhausted battery with
new battery.
Batteries, which are used up dispose duly. Used up batteries
are hazardous and must be given in the for this being
supposed collective container.
-16-
):
" appears.