Using The Display Backlight; Troubleshooting - Albrecht AE 69 H Bedienungsanleitung

Using the Display Backlight

• To turn on the display light for easy viewing at night,
press
The display lights for 15 seconds.
• To turn off the light sooner, press

Troubleshooting

If your AE69H is not performing properly, try the following
steps.
Problem
The
scanner
doesn't
work.
Improper
reception.
Scan won't
stop.
Scan won't
start.
.
Possible
cause
The scanner
might not get
any power.
The
scanner's
antenna
might need
to be
adjusted.
The squelch
might need
to be
adjusted.
The antenna
might need
to be
adjusted.
One or more
channels
might be
locked out.
The
channel's
frequency
might not be
stored in
memory.
The channel
might not be
active.
You must
press Scan
to scan.
The squelch
might need
to be
adjusted.
again.
Suggestion
Check the batteries. Correct
polarity?
Contact problems? Contact
corroded? Clean contacts.
Check the antenna connection or
move or reposition the antenna.
Move the scanner.
You might be in a remote area
that could require an optional
multi-band antenna. Check with
your dealer or local electronics
store.
Adjust the squelch threshold.
See "Turning On The Scanner
and Setting Squelch"
Check the antenna connection.
Make sure the channels you
want to scan are not
locked out.
Make sure the channel's
frequency is stored in the
scanner's memory.
Wait for a transmission on the
channel.
Press Scan.
Adjust the squelch threshold.
See"Turning On The
Scanner and Setting Squelch".
22