Operation; Turning The Scanner On And Setting Squelch; Storing Known Frequencies Into Channels; Scanning The Stored Channels - Albrecht AE 69 H Bedienungsanleitung

Operation

Turning the scanner on and setting squelch

Note: Make sure the scanner's antenna is connected before
you turn it on.
•
Turn Squelch fully counterclockwise.
•
Press and hold
scanner on.
•
Then turn Volume clockwise until you hear a hissing
sound.
•
If the scanner is scanning, press Hold to stop
scanning, then turn Squelch clockwise until the
hissing stops.

Storing known Frequencies into Channels

•
(1) Press Hold. Then enter the channel number
where you want to store a frequency, then press
Func and Pgm. The channel number appears.
•
(2) Use the number keys and ●/Clr to enter the
frequency (including the decimal point) you want to
store.
•
(3) Press E to store the frequency into the channel.
Notes:
•
If you entered an invalid frequency, Error appears and
the scanner beeps three times. Enter a valid
frequency.
•
The scanner automatically rounds the entered number
to the nearest valid frequency. For example, if you
enter 28.473 (MHz), your scanner accepts it as 28.475.
•
When you enter a frequency into a channel, the
scanner automatically turns on the delay function and
DLY appears. When delay is turned on, the scanner
automatically pauses scanning 2 seconds after the end
of a transmission before scanning proceeds to the next
channel.
•
To turn the function off or on, press Func + Dly.
•
If you enter a frequency that has already been entered
elsewhere, the scanner sounds an error tone and
displays the channel that was duplicated. If you
entered the frequency by mistake, press Clr then enter
the correct frequency. To enter the frequency anyway,
press E to accept.
•
To program the next channel in sequence, press
E/ Pgm and repeat Steps (2) and (3) above.

Scanning the Stored Channels

To begin scanning channels, press Scan. The scanner scans
through all non-locked channels. When the scanner finds a
transmission, it stops on it. When the transmission ends, the
scanner resumes scanning.
for about 2 seconds to turn the
16