Chain Search Mode; Chain Search Hold Mode; Storing Frequencies Found During Chain Search Into Channel Memory - Albrecht AE 69 H Bedienungsanleitung

Frequency Range MHz
1 84.0150 -
2 144.0000 - 145.9875
3 156.0000 - 162.0250
4 162.0300 - 173.9900
5 406.0000 - 439.99375
Frequency Range MHz
1 25.0000 -
2 160.6000 - 162.5950
3 162.6000 - 173.9950
4 440.0000 - 465.99375
5 466.0000 - 469.99375
To switch the band plan between 1, 2 and 3:
•
Make sure the power is turned off.
•
While holding down 1, 2, or 3, turn on the scanner.
Note: Please carry out a memory initialization (Reset) after
band plan was changed. We recommend to change the band
plan setting immediately for the correct country setting before
first use of the scanner, later, in most cases, changing will be
no more necessary.

Chain Search Mode

Press Func + Src to start chain search mode. SRCH, the
enabled search bank number, and or (indicating the search
direction) appear. The search bank number being searched
flashes.
Press 1- 5 to enable or disable the search bank number being
searched in this mode. Enabled bank numbers appear, while
disabled bank numbers disappear.
At least one search bank must be enabled. (The scanner
sounds an error tone if you try to disable all the search banks).
The search bank and the frequency where chain search starts
depends on how the scanner was set before you selected
chain search mode.

Chain Search Hold Mode

To start chain search hold mode, press Hold in chain search
mode. The scanner stops searching and HOLD appears.
•
In this mode, pressing Func +
direction downward and pressing Func +
changes the search direction upward.
•
or
direction.
Storing Frequencies Found During Chain Search into
Channel Memory
You can store frequencies you find in chain search mode or
5 Search Bands Band Plan 2
87.2550
5 Search Bands Band Plan 3
29.9950
appears according to the current search
Steps
20 kHz
12.5 kHz
12.5 kHz
10 kHz
6.25 kHz
Steps
5 kHz
5 kHz
5 kHz
6.25 kHz
6.25 kHz
changes the search
18