Select The Power Cables; Ensure The Cooling; Protect The Drive And Input Power Cable; Install The Drive On The Wall - ABB ACH580-01 Kurzanleitung Für Die Installation

174 EN – R5 Quick installation guide

Select the power cables

Size the power cables according to local regulations to carry the nominal current
given on the type designation label of your drive.

Ensure the cooling

R0-
R4
See table I on page
R5
allowed operating temperature range of the drive is -15 to +50 °C (+5 to +122 °F). No
condensation or frost is allowed. For more information on the ambient temperature
R6-
and derating, see chapter Technical data in ACH580-01 (0.75 to 250 kW) hardware
R9
manual (3AUA0000076331 [English]).

Protect the drive and input power cable

EN
See tables III (on page 171) and
fuses.
DA
If you use gG fuses, make sure that the operating time of the fuse is below 0.5
seconds. Follow the local regulations.
DE

Install the drive on the wall

ES
See figure R5 Figures A
FI

Check the insulation of the power cables and the motor

FR
Check the insulation of the input cable according to local regulations before
IT
connecting it to the drive.
See figure B on page 315.
NL
1. Check the insulation of the motor cable and motor when the cable is disconnected
PL
from the drive. Measure the insulation resistance between each phase conductor
and then between each phase conductor and the Protective Earth conductor
PT
using a measuring voltage of 1000 V DC. The insulation resistance of a typical
motor must exceed 100 Mohm (reference value at 25 °C or 77 °F). For the
RU
insulation resistance of motors, see the manufacturer's instructions.
Note: Moisture inside the motor casing will reduce the insulation resistance. If
SV
moisture is suspected, dry the motor and repeat the measurement.
TR
ZH
171 (UL: table II on page 171) for the heat dissipation. The
IV (on page 171); (UL: table
on page 315.
V on page 172) for the