Cleaning And Maintenance; Cleaning The Cuffs; Storage; What If There Are Problems - Beurer FM 150 Pro Gebrauchsanweisung

2. Remove the air hose from the hand switch
within the 30 second standby mode and in-
sert the air hose into the air outlet (
side of the hand switch and press the air outlet
button [5]. All 3 timer LEDs flash at the same
time. They go out again when the process has
ended.
3. Then undo the hook-and-loop fasteners and
take the cuffs off. Remove the air hoses on the
„Y-adapter" from the leg cuffs, but leave the
short end pieces on the leg cuffs as shown.
Also remove the air hose from the adapter that
is located directly on the thigh cuffs. If you used
the device with the mains part, remove it from
the socket and the hand switch.

9. Cleaning and maintenance

9.1 Cleaning the cuffs

• Always switch the device off before cleaning and remove the air hoses (apart from the short end pieces) from
the cuffs and the hand switch.
• Clean the cuffs with a soft, slightly damp cloth. Do not use any chemical or abrasive cleaning agents for cleaning.
• Do not use the cuffs until they are completely dry.

9.2 Storage

• If you do not intend to use the device for longer periods, remove the batteries from the hand-held device. Leak-
ing batteries may damage the device.
• Do not make sharp kinks in the air hoses and the cuffs.
• Store the device and accessories in a cool, well-ventilated space in its original packaging.

10. What if there are problems?

Problem
Cuffs do not inflate
The timer LEDs on the hand-held
device start to flash during the
treatment and the vein massager
switches itself off
If you cannot find a solution to your problem here, contact our Customer Services.
) on the
Possible cause
Batteries are flat
Mains part not plugged in
Air hoses are not correctly connected Reconnect the air hoses.
Batteries are flat
21
Solution
Replace the batteries in the hand
switch.
Plug the mains part into a suitable so-
cket.
Replace the batteries in the hand
switch.