Use; Starting Treatment - Beurer FM 150 Pro Gebrauchsanweisung

8. Use

8.1 Starting treatment

IMPORTANT:
• Avoid undoing the cuff hook-and-loop fastener during use as this could impair the functionality of the device.
Only open the cuff hook-and-loop fastener if the pressure on your legs becomes uncomfortable during use
or press the stop button.
• Make sure the air hoses do not become kinked during use.
• Do not cover the cuffs with a blanket or other objects during use.
1. Always follow the instructions in the "Initial use" section.
2. Place the leg and thigh cuffs one at a time securely
over your thighs, lower legs and feet as shown; have
your legs bare or wear closely fitting clothing (e.g.
tights).
The cuffs should be fastened so that two fingers can
still fit under the cuffs. If the cuffs feel too tight, fas-
ten the cuffs so that you can get your flat hand under
them.
3. For best results, your legs should be elevated/slightly
bent during the treatment to aid circulation.
• Both the leg and thigh cuff for the left leg are marked
with an „L" on the inside.
• Both the leg and thigh cuff for the right leg are marked
with an „R" on the inside.
4. Connect the air hoses to the cuffs. Ensure the air ho-
ses are securely in place and cannot slip.
Connect the other end of the air hose to the air inlet ("in")
on the hand switch.
5. Press the ON/OFF button to switch on the device. Once the
device is switched on, the 20 minute timer LED lights up.
6. Please note that the timer begins to count again when
you change the timer setting.
IMPORTANT
We recommend an application time of 20 to 30 minutes. Using
the massager for long periods could result in a feeling of
numbness in the legs and could cause the device to overheat.
19
R
stop stop
L