Abschnitt 5: Technische Daten zur Schnittstelle
5.13 TECHNISCHE DATEN DER PARALLELSCHNITTSTELLE (CENTRONICS)
Die Parallelschnittstelle des Druckmoduls entspricht dem Centronics- Standard
Grunddaten
Schnittstellenkarte
Stecker
Signalebene
Einstellung
Kommunikation
Maximale Emp-
fangsspeicherkapazität
Zeitdiagramm
Seite 5-12
Drucker
Amphenol- Stecker (DDK) 57 bis 40360
(oder entsprechend)
Kabel
Amphenol- Kabel (DDK) 57 bis 30360
(oder entsprechend)
Kabellänge
Unter 3 Metern
High-Pegel
: + 2.4 to + 5.0 V
Low-Pegel
: + 0,0 to + 0,4 V
Einzel- oder Mehrfachkommunikation kann über den DIP- Schalter
DSW 2-5 gewählt werden.
DIPSW2-5
ON
OFF
2.95Mbyte
0Mbyte
Fast voll
Fast voll beseitigt
ECP-Modus
ECP mode
T1 T2
T1 T2
DATA
DATA
STROBE
STROBE
ACK
ACK
BUSY
BUSY
* 1µs < T1, T2
* 1µs < T1, T2
7µs < T3 < 9µs
0.6µs < T3 < 1.2µs
* It is possible to set the ACK width settings (0.5 – 10 µs) in the Advanced
mode, in the case of One Item reception.
Einstellung
Mehrfachjob
Einzeljob
2.95Mbyte
Verbleiben. 0.95Mbyte
Verbleiben. 1.95Mbyte
Centronics kompatibler Modus
Centronics compatible mode
T1 T2
T3
T1 T2
T3
S8400 Serie Bedienungshandbuch