Service Instructions - Meister MOF1200-1 Originalbetriebsanleitung

5458010-Oberfraese_man 05.02.19 08:55 Seite 69
After finishing work
• Using a dry brush, clean dust and
chips from ventilation slots.
• Clean the outside of the housing with
a slightly moist cloth and allow it to
dry well.
Risk of damage to appliance! Do
not use liquids to clean router!
Do not use solvents!
Repair
Replace carbon brushes
If carbon brushes are worn, the motor will
run unevenly, stop or start sluggishly.
The carbon brushes must be replaced
by approved specialists only.
Fault tracing and repair
• Router will not start? Check supply
socket and associated mains fuses.
Ensure correct mains voltage (see
„Technical Data"). Or: Have carbon
brushes checked by approved
specialists.
• The routed surfaces are rough or
uneven? The router head is blunt or
misaligned. Or: The feed rate is too
high. Or: The speed is too low.
• The routed surfaces are dark
coloured? The router head is
overheating. Allow to cool down! Or:
The feed rate is too high. Or: The
speed is too high.
• The motor slows down considerably
during routing? The feed rate is too
high. Reduce feed rate!
• The motor runs irregularly, stops,
or starts with difficulty? Have the
carbon brushes exchanged by
authorised specialists.
• The router gets very hot? Critical
continuous operation under full load.
Stop work and allow machine to cool
down!
CAUTION! Electrical and battery
operated units that no longer work
should not be disposed of in the
household waste! They are to be
collected separately, in
accordance with the
2012/19/EU directive for the
disposal of electrical and
electronic waste, and sent
for proper and environ -
mentally-friendly recycling.
Please discard power tools no longer
usable at a local collection point.
Collection and disposal of packaging
materials separately by types complying
with local rules and regulations. For
details, please contact your municipal
authority concerned.
11 – Service instructions
• Store the machine, operating
instructions and where necessary the
accessories in the original packaging.
In this way you will always have all the
information and parts ready to hand.
• Meister devices are to a large extent
maintenancefree, a damp cloth being
sufficient to clean the casing. Do not
drop electrical machines in water.
Please note additional hints given in
the operating instructions.
• Meister devices are subject to stringent
quality control. If however a functional
69