Maintenance And Environmental Protection - Meister MOF1200-1 Originalbetriebsanleitung

5458010-Oberfraese_man 05.02.19 08:55 Seite 68
Copy-routing a prescribed shape
Fitting template guide (see section 7
– Installation and setting).
Making a template
Make template from robust material;
material thickness: min. 3 mm.
Note the required offset between template
and workpiece contour! This dimension is
the distance between the template guide
and the router head blade.
Milling
Guide the router so that the template
guide rests against the copy template.
Routing straight cuts
Fitting parallel fence (see section 7 –
Installation and setting).
Setting parallel fence: Loosen grip
screws. set desired distance between
68
parallel fence and router head.
Tighten handle screws tightly.
Guide the router so that the parallel
fence rests against the workpiece edge.
Routing circular workpieces
Fitting centring point (see section
7 – Installation and setting).
With left hand push centring point onto
the workpiece (if necessary, predrill) and
hold firmly. With the right hand guide
the router.
Routing free-hand shapes
Examples: Routing
patterns, cursive writing or
other free-hand shapes
into the workpiece
surface. For free-hand
routing, no aids need be
fitted to the router.
10 – Maintenance and
environmental
protection
Maintenance
• Before starting work: check cable and
mains plug for damage. If faults
occur: do not operate router! Have
fault repaired by approved specialist!
• While routing: empty connected
vacuum cleaner at regular intervals.
Blocked extractor ducts cause chips
to collect in the work zone!
Cleaning
Risk of injury! Always unplug
from mains before cleaning!