About This Documentation; Conventions Used - Lenze L-force 9400 Inbetriebnahme-Leitfaden

9400 HighLine | Commissioning guide

About this documentation

Conventions used

1 About this documentation
This documentation is a guide for (initial) commissioning 9400 HighLine controllers. It
complements the mounting instructions supplied with the controller, the hardware
manual, and the software manual for the controller.
Target group
This documentation is intended for qualified staff according to IEC 364.
Information on validity
The information in this documentation is valid for the following standard devices:
Product range
9400 Servo Drives
Document history
Material number
13237623
Copyright information
All texts, photos and graphics contained in this documentation are subject to copyright
protection. No part of this documentation may be copied or made available to third parties
without the explicit written approval of Lenze Drive Systems GmbH.
Liability
All information given in this documentation has been carefully selected and tested for
compliance with the hardware and software described. Nevertheless, discrepancies
cannot be ruled out. We do not accept any responsibility or liability for any damage that
may occur. Required correction will be included in updates of this documentation.
1.1 Conventions used
This documentation uses the following conventions to distinguish between different types
of information:
Type of information
Spelling of numbers
Decimal separator
Text
Program name
Window
Control element
24
Type designation From software version
E94AxHExxxx 3.0
Version Description
1.0 02/2008 TD05 First edition
Writing Examples/notes
Point Generally, the decimal point is used.
For example: 1234.56
» « The Lenze PC software »Engineer«...
Italics The Message window... / The Options dialog box...
Bold The OK... button / The Copy... command / The
Properties...tab
EDB94AxH6954 DE/EN/FR/ES/IT 1.0
L