Heater Installation - Sawotec NR-45NB Bedienungsanleitung

Heater Installation

It is recommended that the heater be placed on the wall nearest to the door. The air
circulation created by the door should work together with the hot air generated by the
heater. For safety and convenience, follow the minimum safety distances as provided in Fig. 1.
Follow the cubic volumes given in Fig. 7. Do not install the heater to the floor or wall niche.
Install only one heater in a sauna room.
Be sure to build a strong foundation for the mounting rack (e.g. cross struts in sauna
paneling) or reinforce the wall with a thick board to prevent the heater from collapsing.
Attach the heater to the wall with the aid of the mounting rack. Screws areprovided for
fastening of the rack to the wall. To affix the heater to the rack, lift the heater and fit the nuts.
Lock at least one of the side screws to prevent the heater from being accidentallymoved.
A certified electrician must do the installation of the heater to ensure safety and reliability.
Improper electrical connections can cause electric shock or fire. Refer to the electrical
diagram in Fig.5.
An electrical supply cable must be connected to the terminal block inside the control unit
through the cable channel.The cable must be HO7RN-F type or its equivalent.To connect the
cable, the control unit must be opened (Fig. 3A).
The heater gets very hot.To avoid the risk of accidental contact with the heater, it is
recommended that a heater guard be provided. Reserve enough space for operation of the
timer and thermostat knobs. Follow the directions given in Fig. 2.
Abb. 2
Fig. 2
Min 5
Note : Reflector must be installed
to prevent risk of fire.
Installation des Hitzeschildes
How to install the reflector
Vergewissern Sie sich, dass das
Hitzeschild auf der Rückseite des
Ofenrahmens eingerastet ist.
Make sure that the heat reflector
shield is placed at the back
part of the heater
frame.
Min 20
Schrauben
Screw
Rahmen
Frame
Hitzeschild
Reflector
ENGLISH