Commissioning; Filling The Tank; Removal From Service - Reflex Storatherm Aqua Load Serie Betriebsanleitung

6

Commissioning

The responsible installer must explain to the operator how the tank functions and how it is to be used.
He/She must draw attention to maintenance work that has to be carried out at regular intervals. The
service life and correct functioning of the tank are dependent on this. The tank must be emptied if
there is a risk of frost, or prior to its being removed from service.
6.1

Filling the tank

Proceed as follows when filling the cylinder:
1. Prior to first filling, rinse the cylinder and pipes with water.
– Dispose of the water into the collection tray, .
2. Fill the cylinder with water until bubble-free water escapes from the open hot water drawing
point.
3. Check the connecting fittings for leaks.
– If necessary, tighten the connecting fittings.
ATTENTION
System damage
During the heating phase, water escapes at the safety valve due to expansion of the water.
• Do not close the safety valve.
7

Removal from service

Remove the cylinder from service when requested to do so in the heating appliance operating
manual,see chapter 8.1 "Draining" on page 14
Note!
Empty the cylinder when removing from service.
– If there is a risk of frost.
– During maintenance.
.
Storatherm — 25.07.2018
Commissioning
English — 13