Operating The Machine; Starting The Engine; Stopping The Engine; Cleaning The Machine - Viking MB 2 R Gebrauchsanleitung

11. Operating the machine

11.1 Starting the engine

Avoid damage to the machine.
Do not start the engine in tall grass
or at the lowest cutting height. This
makes starting difficult.
Thanks to the fixed throttle setting,
the engine always operates at the
optimum working speed after
starting.
Starting procedure when the engine is
cold:
● Only for MB 2 R:
Press the primer (1) three times.
● Press the motorstop lever (2) to the
handlebar and hold.
● Slowly pull out the recoil starter rope (3)
to the point of compression resistance.
Then pull vigorously and quickly to
arm's length. Slowly return the recoil
starter rope (3) so that it is rolled up
again.
Repeat the procedure until the engine
starts.
Starting procedure when the engine is
warm:
Avoid damage to the machine.
The primer must no longer be
pressed when the engine is warm.
It should be remembered, however,
that the engine can cool down
rapidly in very cold weather.
0478 111 9926 A - EN
● The starting procedure is the same as
when the engine is cold.
Only for MB 2 R:
It is not necessary to press the
primer (1).
9

11.2 Stopping the engine

● Release the motorstop lever (1).
The engine and blade come to a
standstill within 3 seconds.
11.3 Self-propulsion (MB 2 RT)
Note
The MB 2 RT model features front-
wheel drive.
1 Switching on self-propulsion
● Start the engine. (
● Pull the self-propulsion
lever (1) to the handlebar
and hold.
Self-propulsion is activated and the lawn
mower moves forwards.
2 Switching off self-propulsion
● Release the self-propulsion lever (1).
Self-propulsion is deactivated and the
lawn mower comes to a standstill.
The engine and blade continue to run.
12. Maintenance
10
11
Annual service by the specialist dealer:
The lawn mower should be inspected once
11.1)
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.

12.1 Cleaning the machine

Maintenance interval:
After each use.
Place the machine in the cleaning
position.
● Open the quick-clamping devices (1)
and fold down the handlebar (2) to the
rear.
Risk of injury!
Carefully read the section "For your
safety" ( 4.), particularly the
subsection "Maintenance and
repairs" ( 4.7), and follow all
safety instructions exactly before
performing any maintenance or
cleaning operations on the
machine.
Allow the machine too
cool and detach the
spark plug socket before
performing any
maintenance or cleaning
operations.
Risk of injury!
Stop the engine, allow the machine
to cool and detach the spark plug
socket.
Empty the fuel tank (run empty)
before placing the machine in the
cleaning position.
12
37