Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel eBOX MFS-V3 Betriebsanleitung

eBOX

8 Putting out of operation

NOTICE
• Please make sure that the shutdown procedures for all components mounted in the welding system are
 Fig. 11 eBOX control elements on page EN-18
1 Use the main switch (16) to cut the power to the eBOX.

9 Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Close the gas supply.
• Disconnect the mains plug.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel
• Always wear your personal protective equipment when performing maintenance and cleaning work.
strictly observed before putting out of operation begins.
DANGER
DANGER
(in Germany see TRBS 1203).
8 Putting out of operation
EN - 19