SOLIS 586 Bedienungsanleitung Seite 52

13. If you want to reheat the water to the set temperature, you can simply touch
the ON/OFF button again resp. change the temperature setting.
Caution: The appliance will only switch on and heat the water if the difference
between current water temperature and set water temperature is at least 5°C.
14. If you do not need any more hot water, pull the power plug, pour the remain-
ing water out of the kettle and let the appliance cool down.
Tips:
• To save energy, the appliance can not be immediately reactivated after heating
water to 100°C. The water in the kettle has to have cooled down to about 90°C
before you can restart the boiling process.
• Do not tilt the filled kettle too much and never turn it upside down, even when
the lid is firmly shut. Water can escape even when the lid is closed!
• Always make sure that the lid is locked to the kettle before switching on the
appliance.
• To lower the pressure in the kettle, it is recommended to keep the button for
unlocking the spout latch pressed for a few seconds after the boiling process
before lifting and emptying the kettle.
■
O V E R H E AT P R O T E C T I O N
• Should the appliance overheat, f.e. if there is no or too little water in the kettle
or if it has already evaporated, the appliance automatically switches off. In this
case, pull the plug and let the appliance cool down for approx. 15 minutes before
using it again.
52