Operation - SOLIS 586 Bedienungsanleitung

▲

OPERATION

1. Place the appliance base on a dry, even work space out of the reach of children.
Place the power cord so that the appliance can not by pulled down by it.
2. Take the kettle, push both lid locks inward and simultaneously lift off the lid.
3. Fill cold tap water into the kettle (note the MAX marking in the kettle, max. 1,5
liters) and replace the lid on the kettle by pushing the lid locks inward again to
perfectly close and lock the kettle. Caution: The lid must be properly placed on
the kettle and locked when heating water.
4. If necessary, dry the outside and bottom of the kettle. Place the kettle on the dry
appliance base.
5. Place the power plug in a suitable power outlet. The dots on the temperature
bar light up briefly in blue and a beep is sounded.
6. Touch the ON/OFF button, the
7. Set the desired water temperature by either touching the
the temperature or the
perature between 40°C and 100°C at steps of 10°C. The dot lights up blue in
accordance with the set temperature.
8. After you have set the temperature, the appliance will take a few seconds before
starting to heat the water. You can tell the temperature rising and what tem-
perature the water currently has by the red dots on the control panel.
9. Once the set temperature is reached, the blue dot changes to a red dot and all
the other dots at the lower temperatures go out. A single beep is sounded, the
appliance automatically switches to standby mode and the light by the ON/OFF
button goes out. The light at the current water temperature keeps glowing red.
10. When the water slowly cools down, the red dot on the temperature bar on the
control panel will move accordingly. You can tell the current temperature of the
water in the kettle from the position of the red light.
11. Carefully lift the kettle off the appliance base, press the button for unlocking the
spout latch and carefully pour the water through the spout into a prepared con-
tainer. Alternatively, you can remove the lid by pushing both lid locks inward and
simultaneously lifting off the lid. For safety reasons, we recommend always pour-
ing boiling water through the spout and not lifting off the lid.
Caution: Always be careful not to burn or scald yourself on the hot steam escap-
ing from the spout or the kettle opening!
12. Should there be any water left in the kettle that you want to keep hot, you can
place the kettle back on the appliance base. The current water temperature can
be told from the position of the red light.
symbol lights up in blue.
3
button to decrease the temperature. You can set a tem-
4
button to increase
51