Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REPLACING THE LED BULB
Do not remove the indicator cover or indicator yourself when the
internal or external LEDs no longer operate. Contact the service
representatives.
INSTALLATION AND OPERATION OF YOUR REFRIGERATOR
Before using the refrigerator, you must pay attention to the following points:
•
The operating voltage of your refrigerator is 220–240 V at 50 Hz.
GB
•
The power cable of your refrigerator has a grounded plug. This plug must be grounded in a grounded
socket that has a fuse of at least 16 amps. If you do not have a socket that meets this requirement, have it
installed by a qualifi ed electrician.
•
We are not liable for any damage that may occur due to ungrounded usage.
•
Place the refrigerator where it will not be exposed to direct sunlight.
•
Your appliance must be at least 50 cm away from an oven, gas oven or burner and be at least 5 cm away
from an electric oven.
•
Your refrigerator must not be used outdoors or left in the rain.
•
When your refrigerator is placed near the freezer, there must be a distance of at least 2 cm between them
to prevent the formation of moisture on the outside surface.
•
Do not place anything on the refrigerator and place it in a suitable location so that a minimum of 30 cm is
left above the top. When installing, make sure that there is a 10 cm clearance from each side and from rear.
•
The adjustable front feet must be adjusted to a suitable height so that the freezer can operate stably and
correctly. You can adjust the feet by turning them clockwise (or in the opposite direction). This must be
done before placing food in the refrigerator.
•
Before using the freezer, wipe all internal surfaces and drawers with a cloth dipped in warm water with
a spoon of baking soda and then rinse with clean water and dry. Replace all parts after cleaning.
•
Install the plastic spacer (part with black blades in the back) by 90° rotation as shown to prevent touching
the condenser touching the wall.
•
The refrigerator must be positioned so that the free space does not exceed 75 mm.
Changing the door opening side
1) Remove the hinge cover.
48
2) Unscrew the top hingeplate.
Werbung
Inhaltsverzeichnis
