Operating And Display Elements; Installing And Connecting The Device; Attaching The Control Panel - Dometic TankMate DTM05C Bedienungsanleitung

TankMate DTM05C
You can also connect an extra lamp or a buzzer to warn you when the tank
is empty or ¾ full.
You can also connect an analogue gauge parallel with the control panel.
5.1

Operating and display elements

No. in fig. 2,
Designation
page 3
1 Red LED
2 Yellow LED
3 Green LED
4 Blue LED
5 On/Off button
6

Installing and connecting the device

6.1

Attaching the control panel

I
NOTE
z Select a suitable place for the control panel, e. g. in the
head/toilet or near your sewage tank.
z Prepare an opening of at least 4 x 22 mm for the cable of the
control panel.
z You can extend the control panel cable by up to 50 metres with
a standard PC network cable (CAT5).
➤ Connect the control panel using the plugs on control panel cable to the
control unit (fig. 3, page 3).
➤ Carefully remove the protective film from the adhesive strip on the control
panel.
➤ Position the control panel in the required place.
➤ Press the control panel down firmly for a few seconds.
EN
Installing and connecting the device
25