Geared Motor Installation - entrematic Ditec LUXO Technisches Handbuch

6.3 Geared motor installation

- Open the lock flap [10] unscrew the screw [F] and remove the cover [9]. Unscrew the screw
[G] and remove the drive screw cover [12] as shown in the figure on pag. 7. Release the piston
(see OPERATING INSTRUCTIONS).
- Mount the piston on tail [14] and head bracket [15], tightly screwing down the self-locking nut
and lubricate the turning points.
NOTE: pay special attention to the correct assembly of the washer on the head bracket.
LUXO3BH
14
- Fit and secure the drive screw cover [12] on the drive screw [13] by means of the screws provided
[G]. NOTE: ensure that the drive screw [13] is properly inserted onto the screw cover head [12]
(see figure).
- Move the gate by hand and check for smooth and free movement throughout.
LUXO3BH
13
28
LUXO3B
LUXO4BH
LUXO5B
LUXO5BH
LUXO5VBH
14
LUXO3B
LUXO4BH
LUXO5B
LUXO5BH
LUXO5VBH
12
13
13
15