Ht 40 Flexx Handheld Transmitter; Controls - AKG HT 40 series Bedienungsanleitung

HT 40_2007_Hex:Layout 1
2.5 HT 40 FLEXX
Handheld Transmitter

2.5.1 Controls

Fig. 2: Controls on HT 40
FLEXX handheld transmitter
Refer to fig. 2.
18
01/14/2008 17:08
2 Description
4 Battery compartment lid: Refer to section 3.1.
5 Carrier frequency label: The label above the battery compartment indicates the car-
rier frequency and approval marks of your transmitter.
Operating in the 660 MHz to 865 MHz UHF range, the HT 40 FLEXX provides three selec-
table, quartz stabilized carrier frequencies within the 3-MHz-wide frequency band for which
you ordered your WMS 40 FLEXX. The antenna is integrated in the body.
The microphone element permanently mounted on the transmitter uses a high quality car-
dioid transducer from AKG. It provides low handling noise sensitivity, high gain before feed-
back, and brilliant sound quality, as well as a built-in wind and pop filter to reduce wind and
breath noise.
1 On/off switch: This slide switch provides three positions:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the microphone element is muted while power and the
RF carrier frequency remain on.
OFF: Power to the transmitter is off.
2 Status LED: Indicates the transmitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment the LED changes to red, the battery capacity will provide
a maximum of two operating hours. We recommend replacing the battery with a new one
as soon as possible.
Note: • If you use a rechargeable battery, the LED will change to red 15 minutes before the bat-
tery will be dead!
3 Frequency selector: This slide switch tunes the transmitter to one of three different
carrier frequencies within the transmitter's carrier frequency band.
4 GAIN: This slide switch sets the transmitter's audio input gain in two stages, "HIGH"
(high gain) or "LOW" (low gain).
5 Color code clip: The color of this plastic clip indicates the carrier frequency band of
your transmitter. Re ceivers tuned to the same frequency band are marked with the same
color. Refer to the Manual Supplement sheet for a color code table.
You can remove the color code clip on the HT 40 FLEXX and replace it with the supplied
semitransparent clip.
6 Battery compartment lid: Refer to section 3.1.
7 Carrier frequency label: The label above the battery compartment indicates the name
of the carrier frequency band and the three carrier frequencies of your transmitter.
Seite 18 (Schwarz/Black Auszug)
HT 40 PRO/FLEXX