Interfacing; Introduction; B 29 L Or Mpa V L; Connecting To A Bodypack Transmitter - AKG MicroMic C516 ML Bedienungsanleitung

The C 516 ML is a condenser microphone and
therefore needs a power supply.
Using any power supply other than those
recommended by AKG may damage your
microphone and will void the warranty.
1. Use the supplied connecting cable to connect
• To disconnect the cable, press the unlocking
• To avoid damaging the cable, never pull
2. B 29 L: Connect the B 29 L to the desired input.
• Use the supplied connecting cable to connect
• You can attach the bodypack transmitter to your
AKG C 516 ML
Downloaded from www.Manualslib.com
the output socket (4) on the gooseneck to one
of the two mini XLR sockets on the B 29 L or
the mini XLR socket on the connecting cable of
the MPA V L.
The connector will lock automatically.
button on the mini XLR connector (1) and pull
the connector (1) out of the socket.
at the cable itself!
MPA V L: Connect the MPA V L to a balanced
XLR microphone input with phantom power
and switch the phantom power on.
the output socket on the gooseneck to the in-
put socket on the bodypack transmitter.
belt or to the instrument. The PT 40 and PT 400
bodypack transmitters will also mount directly on
the microphone.
manuals search engine

2 Interfacing

2.1 Introduction

Important!
2.2 B 29 L
or MPA V L
Disconnecting
the cable:
Important!
2.3 Connecting
to a Bodypack
Transmitter
Note:
Refer to section
2.3.1 on page 18.
17