Description; Introduction; Packing Lists; Optional Accessories - AKG HT 40 series Bedienungsanleitung

HT 40_2007_Hex:Layout 1
Thank you for purchasing an AKG product. This Manual contains important instructions for
setting up and operating your equipment. Please take a few minutes to read the instruc-
tions below carefully before operating the equipment. Please keep the Manual for fu-
ture reference. Have fun and impress your audience!
1 HT 40 PRO or HT 40 FLEXX handheld transmitter
1 stand adapter
1 AA size battery
1 semitransparent color clip
1 Manual Supplement sheet
• Check that the packaging contains all of the items listed for your system. Should any of
these items be missing, please contact your AKG dealer.
• For optional accessories, refer to the current AKG catalog or folder, or visit www.akg.com.
Your dealer will be glad to help.
The HT 40 PRO handheld transmitter operates on a single fixed, quartz stabilized frequency
in the 660 MHz to 865 MHz UHF carrier frequency range and uses an antenna integrated in
the body.
The microphone element permanently mounted on the transmitter uses a high quality car-
dioid transducer from AKG. It provides low handling noise sensitivity, high gain before feed-
back, and brilliant sound quality, as well as a built-in wind and pop filter to reduce wind and
breath noise.
1 On/off switch: This slide switch provides three positions indicated in the display win-
dow:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the microphone element is muted while power and the
RF carrier frequency remain on.
OFF: Power to the transmitter is off.
2 Status LED: Indicates the transmitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment the LED changes to red, the battery capacity will provide
a maximum of two operating hours. We recommend replacing the battery with a new one
as soon as possible.
• If you use a rechargeable battery, the LED will change to red 15 minutes before the bat-
tery will be dead!
3 Color code clip: The color of this plastic clip indicates the carrier frequency of your
transmitter. Re ceiver channels tuned to the same frequency are marked with the same
color. Refer to the Manual Supplement sheet for a color code table.
You can remove the color code clip on the HT 40 PRO and replace it with the supplied
semitransparent clip.
HT 40 PRO/FLEXX
01/14/2008 17:08 Seite 17 (Schwarz/Black Auszug)

2 Description

2.1 Introduction

2.2 Packing List

2.3 Optional Accessories

2.4 HT 40 PRO
Handheld Transmitter

2.4.1 Controls

Fig. 1: Controls on HT 40 PRO
handheld transmitter
Refer to fig. 1.
Note:
17