Safety Guidelines - Hirschmann RH1- FL Betriebsanleitung

We have checked that the contents of the
technical publication agree with the hard-
ware and software described. However, it is
not possible to rule out deviations comple-
tely, so we are unable to guarantee comple-
te agreement. However, the details in the
technical publication are checked regularly.
Any corrections which prove necessary are
contained in subsequent editions. We are
Note
We would point out that the content of
these operating instructions is not part of,
nor is it intended to amend an earlier or exi-
sting agreement, permit or legal relation-
ship. All obligations on Hirschmann arise
from the respective purchasing agreement
which also contains the full warranty condi-
General
Electricity is used to operate this equip-
ment. Comply in every detail with the safety
requirements specified in the operating
instructions regarding the voltages to
apply!
Staff qualification
requirements
Qualified staff within the meaning of these
operating instructions or the warning notes
are persons familiar with setting up, assem-
bling, starting up and operating this product

Safety guidelines

Warning!
v
The RH1-TP/FL units are designed
for operation with safe extra-low
2
grateful for suggestions for improvement.
We reserve the right to make technical
modifications.
Permission is not given for the circulation
or reproduction of this document, its use or
the passing on of its contents unless gran-
ted expressly. Contravention renders the
tions which have sole applicability. These
contractual warranty conditions are neither
extended nor restricted by comments in
these operating instructions.
We would furthermore point out that for
reasons of simplicity, these operating
instructions cannot describe every
conceivable problem associated with the
Warning!
v
If warning notes are ignored, it is
therefore possible for severe injuries
and/or material damage to occur.
Only appropriately qualified staff
should work on or near this equip-
ment. Such staff must be thoroughly
acquainted with all the warnings
and who have appropriate qualifications to
cover their activities, such as:
– training or instruction/entitlement to
switch circuits and equipment/systems on
and off, ground them and identify them in
accordance with current safety standards;
voltage. Accordingly, only safe
extra-low voltages (SELV) to
IEC950/EN60950/VDE0805 may be
perpetrator liable for compensation for
damages. All rights reserved, in particular
in the case of patent grant or registration of
a utility or design.
Copyright © Richard Hirschmann GmbH &
Co 1998
All Rights Reserved
use of this equipment. Should you require
further information or should particular
problems occur which are not treated in
sufficient detail in the operating instruc-
tions, you can request the necessary infor-
mation from your local Hirschmann sales
partner or directly from the Hirschmann
office (address: refer to chapter entitled
„Notes on CE identification").
and maintenance measures contai-
ned in these operating instructions.
The proper and safe operation of
this equipment assumes proper
transport, appropriate storage and
assembly and careful operation and
maintenance.
– training or instruction in accordance with
current safety standards in looking after
and using appropriate safety equipment;
– first aid training.
connected to the supply voltage
connections.