Problems And Remedies - Nilfisk-Advance SR 1700 2WD B Betriebsanleitung

PROBLEMS AND REMEDIES

The following table shows the most common problems that may arise during the use of the machine, the possible causes and
the suggested remedies to solve them.
WARNING!
When applying a recommended solution, always follow the instructions relating to it.
NOTE
Do not hesitate to contact Nilfisk-Advance if a problem cannot be solved by following the instructions
provided.
PROBLEMS AND REMEDIES
PROBLEM
Heavy material not collected/traces of dirt
left behind during use
Excessive amount of dust left on the ground
or coming out of skirts
Material is thrown forward
Engine fails to start
Machine power is reduced
Machine fails to run
Machine fails to brake
Hard power steering
Hopper fails to lift/lower
Waste loss from hopper
Filter shaker fails to operate
Blown filter shaker fuse
Noisy fan
Fan fails to operate
Skirt fails to open
Skirt gasket lifted by broom
33014816(1)2005-07 A
CAUSE
Excessive drive speed
Light print
Worn out broom
Broom bristles bent or tangled with steel wire,
ropes etc.
Fan off
Clogged filters
Broken skirt gasket
Blown general fuse
Blown safety fuse
Discharged battery
Insufficient pump oil feed
Worn motors
Open by-pass
Faulty pedal
No power to pump or motors
No brake fluid
Brake fluid pump failure
Air inside the system
Jaw cylinders failure
Worn or greasy brake lining
Locked power steering
Priority valve failure
Locked distributor
Locked cylinder
Broken hopper gasket
Broken push-button
Blown fuse
Excessive motor absorption due to:
– Worn carbon brushes
– Dirty or worn bearings
– Burnt armature or winding
Excessive motor absorption
Faulty fuse
Shorted cables
Motor failure
No voltage to motor
Motor failure
No pressure to cylinder
Locked linkage
Gasket is too long
USER MANUAL
REMEDY
Decrease drive speed
Adjust print
Replace the brooms
Remove any tangled material
Switch on the fan
Clean filters
Replace
Replace fuse
Replace fuse
Charge battery
Check by-pass screw tightening
Check pump pressure (16 to 20 Bar)
Overhaul pump
Overhaul motor
Check by-pass screw tightening
Replace pedal
Overhaul pump
Overhaul motor
Top up fluid tank
Overhaul pump
Bleed system
Replace cylinders
Replace brake lining
Replace power steering
Overhaul/replace priority valve
Check distributor
Check cylinder
Replace gasket
Replace
Replace
Replace
Replace
Replace
see above
Replace
Check system
Overhaul motor
Check electrical system
Overhaul motor
Check system
Check linkage
Shorten/replace
11