Machine Stop - Nilfisk-Advance SR 1700 2WD B Betriebsanleitung

USER MANUAL
When necessary, dump the hopper as follows:
– Lift the main broom.
– Lift the side broom.
– Close the skirt.
– Drive the machine to the appointed dumping area.
– Lift the hopper to the correct dumping height.
– Open the skirt.
– Lower the hopper.
– Close the skirt.
– Activate the filter shaker for approx. 20 seconds.
– Lift the right side (left side optional) broom and the main
broom by pressing the push-button. The brooms stop
rotating.
– By pressing the push-button lift the hopper to the
required dumping height.
WARNING!
Move the machine extremely slowly when the
hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a
slope.
– Skirt opening: open the skirt by pressing the joystick
push-button.
– Make sure that the skirt closing panel is completely
open.
WARNING!
When dumping the hopper, make sure that
nobody is near the machine.
– Press the push-button to lower the hopper, so that it is
supported by the rubber buffers on the frame.
WARNING!
Do not activate the filter shaker with the hopper
in the lifted position.
– Skirt closing: press the push-button to close the skirt
closing panel.
– Operate the filter shaker by pressing the push-button.
WARNING!
Do not activate the filter shaker with the hopper
in the lifted position.
10

MACHINE STOP

At the end of the working shift, stop the sweeper in the
appointed area with:
– Brooms in the lifted position;
– Hopper in the lowered position;
– Parking brake lever engaged;
– Lights off (if on);
– Engine off;
– Ignition key removed.
WARNING!
Never leave the hopper in the lifted position
without using the safety props (1, Fig. L).
33014816(1)2005-07 A