Cleaning And Maintenance; Cleaning; Periodical Maintenance; Maintenance Table - Nilfisk-Advance SR 1700 2WD B Betriebsanleitung

USER MANUAL

CLEANING AND MAINTENANCE

The machine cleaning can be carried out by non-specialized
personnel. However, the person in charge of the cleaning
should be familiar with the energy source cut-off main
controls and the main features of the machine to avoid any
dangerous situation.
The machine maintenance should be carried out by highly
skilled personnel, with a deep knowledge of the machine and
its components.
Mechanical, electrical and electronic maintenance is
possible.
WARNING!
Any cleaning and maintenance operation
should be carried out with the machine off.
Wait for all the parts to stop and cool down.
WARNING!
Protect eyes and hair when cleaning the
machine with compressed air guns.
If the machine is working in a toxic
environment, wear a special mask and
adequate protective clothing when carrying
out maintenance work on the dust filter.

MAINTENANCE TABLE

Maintenance
Hydraulic oil level check
Closed pocket filter cleaning
Battery check
Brake fluid level check
Battery check
Dust control system water filter check
Gear pump hydraulic oil filter replacement
Hydrostatic pump hydraulic oil filter replacement
Hydrostatic pump hydraulic oil filter replacement
Screw tightening
Hydraulic oil change
Motor carbon brush check
Hydraulic motor and pump pressure check
Brake system check
Moving part clearance check
14

CLEANING

Machine general cleaning
Clean the coating, panels and controls of the machine with a
soft cloth, either dry or lightly soaked in a mild detergent
solution.
NOTE
Do not use solvents such as alcohol, petrol or
ethyl acetate as they could damage the
surfaces.
Remove traces of dust and other dirt from the machine control
panels (digital displays, indicator and warning lights,
switches).
NOTE
Pay attention when cleaning the electrical
components.
If necessary, the electrical components should be cleaned
only by specialized personnel and non-corrosive products
suitable for electric circuits should be used.

PERIODICAL MAINTENANCE

WARNING!
Any cleaning and maintenance operation
should be carried out with the machine off.
Wait for all the parts to stop and cool down.
For the engine maintenance, please follow the instructions
provided in the Use and Maintenance Manual concerning the
engine installed on the sweeper. This manual comes in a
special case.
Recommended periodical maintenance operations are
summarized in this table.
Every 10 Every 20 After 50
hours hours hours
Every
Every 150 Every 300
1,000
hours hours
hours
33014816(1)2005-07 A
Every
2,000
hours