Use; Before Machine Start-Up; Machine Start And Stop - Nilfisk-Advance SWEEPER SR 1000S P Betriebsanleitung

USER MANUAL

USE

WARNING!
On some points of the machine there are some
adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– NOTE
While reading this Manual, the operator must pay particular
attention to these symbols.
Do not cover these plates for any reason and immediately
replace them if they are damaged.

BEFORE MACHINE START-UP

CAUTION!
Make sure that there are no open doors/hoods
and that the machine is in normal operating
conditions.
Make sure that the hopper (20, Fig. C) is
properly closed.
If the machine has not been used after being
transported, check that all the blocks used for
the transportation have been removed.
1. If necessary, remove the cap (36, Fig. C) and refuel the
machine; if necessary, to gain access to the cap (36),
move the seat (29) forward with the adjusting lever (34).
CAUTION!
Do not fill the fuel tank beyond the upper limit
mark (1, Fig. T).
2. Open the hood (10, Fig. C) and open the fuel tap (1, Fig.
V), then close the hood again.

MACHINE START AND STOP

Starting the machine
1. Sit on the driver's seat (29, Fig. C) and, if it is necessary
for an easier access to the machine, push the lever (11,
Fig. B) and tilt the steering column (31, Fig. C) forward.
2. Push the lever (11, Fig. B) forward and tilt the steering
column (31, Fig. C) forward or backward, to reach a
comfortable position. Then release the lever (11, Fig. B)
and lock the steering column.
3. Only in case of very low temperatures, turn the engine
choke lever (1, Fig. W) to closed position (2) by
introducing your hand into the compartment (37, Fig. C),
without opening the hood (10, Fig. C).
8
4. Turn the ignition switch (2, Fig. B) to "II" and start the
engine. When the engine starts, release the ignition
switch immediately.
CAUTION!
When starting the engine with the ignition
switch (2, Fig. B) do not press the drive pedal
(5, Fig. B).
CAUTION!
Engine cannot start when the hood (10, Fig. C)
is open. A safety system prevents the engine
from starting.
CAUTION!
When the engine is running, the main broom
rotates, while the side brooms do not move, if
lifted.
When the engine is running, the vacuum fan is
always operating.
5. 5 seconds after the engine has been running, disengage
the engine choke lever (1, Fig. W) by introducing your
hand into the compartment (37, Fig. C), without opening
the hood (10, Fig. C).
6. Disengage the parking brake according to the following
procedure:
– Press the pedal (6, Fig. C) and turn the lever (7, Fig.
C) from (7a) position to (7b) position.
– Release the pedal (6).
7. Drive the machine to the working area, by keeping the
hands on the steering wheel and pressing the pedal (5,
Fig. C) on the front side to move forward and on the rear
side to move backward.
The drive speed can be adjusted from zero to maximum
speed by increasing the pressure on the pedal (5, Fig.
C).
NOTE
The seat (29, Fig. C) is equipped with a safety
sensor, which allows the machine to be driven
by pressing the pedal (5, Fig. C) only when the
operator is on the driver's seat.
8. Turn on the vacuum system with the lever (3, Fig. C).
9. Lower the side brooms (13 and 14, Fig. C) by lowering
the lever (4).
NOTE
The side brooms (13 and 14, Fig. C) can be
lowered and lifted even when the machine is
moving.
The side brooms do not rotate when they are
lifted, but they rotate when they are lowered.
10. Start sweeping by turning the steering wheel (1, Fig. C)
and move the machine forward by pressing the pedal
(5).
146 1960 000(2)2006-06 A