Troubleshooting Guide - EINHELL BG-PM 40 B&S Originalbetriebsanleitung

Anleitung_BG_PM_40_BS_SPK7:_

10. Troubleshooting guide

Warning: Switch off the engine and pull out the ignition cable before making any checks or adjustments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that
the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Important. If problems arise in connection with the engine, please refer to the enclosed manual from
Briggs & Stratton.
Fault
The equipment does not operate
smoothly and vibrates intensively
The engine does not start
Lawn turns yellow,
uneven cut
Grass chute is not clean
29.07.2010 10:43 Uhr Seite 29
Possible cause
- Bolts loose
- Blade attachment is loose
- Blade imbalanced
- Brake lever not pushed
- Fuel tank empty
- Blade is not sharp
- Cutting height too small
- Cutting height too small
- Blade is worn
- Grass bag is clogged
GB
Remedy
- Check bolts
- Check blade attachment
- Replace blade
- Push brake lever
- Top up fuel
- Sharpen blade
- Adjust to the proper height
- Set properly
- Replace the blade
- Empty the grass bag
29