Troubleshooting Guide - EINHELL GE-PM 53/2 S HW-E Li Originalbetriebsanleitung

9. Troubleshooting guide

Warning: Switch o the engine and pull out the spark plug boot before making any checks or adjust-
ments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remem-
ber that the exhaust and other parts will get hot. Do not touch these parts as they may burn you.
Fault
The equipment - Bolts loose
does not operate - Blade attachment is loose
smoothly and vibra- - Blade imbalanced
tes intensively
The engine does - Engine start/stop lever is not
not start pressed
- Throttle lever in wrong position (if
provided)
- Spark plug defective
- Fuel tank empty
- Fuel pump (primer) not actuated (if
provided)
Engine does not run - Air lter dirty
smoothly - Spark plug dirty
Lawn turns yellow, - Blade is not sharp
uneven cut - Cutting height too small
- Engine speed too low
Grass chute is not - Engine speed too low
clean - Cutting height too small
- Blade is worn
- Grass bag is clogged
Starter does not - Battery empty
turn - Battery not connected
- Safety plug not tted
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
GB
Possible cause
- 36 -
Remedy
- Check bolts
- Check blade attachment
- Replace blade
- Press the engine start/stop lever
- Check setting (if provided)
- Replace spark plug
- Top up fuel
- Actuate the fuel pump (primer) (if
provided)
- Clean the air lter
- Clean the spark plug
- Sharpen blade
- Adjust to the proper height
- Set the throttle lever to max. (if pro-
vided)
- Set the throttle lever to max.
- Set properly
- Replace the blade
- Empty the grass bag
- Charge battery
- Connect battery
- Fit safety plug