Special Information - AEG MTH series Bedienung Und Installation

◦ The appliance is not suitable for supply-
ing a shower (shower operation).
◦ Ensure the appliance can be separated
from the power supply by an isolator that
disconnects all poles with at least 3 mm
contact separation.
◦ The specified voltage must match the
mains voltage.
◦ Connect the appliance permanently to
fixed wiring, exception MTH 350.
◦ The power cable must only be replaced
(for example if damaged) by a qualified
contractor authorised by the manufactur-
er, using an original spare part.
◦ Fix the appliance in position as de-
scribed in chapter „Installation /
Preparations".
◦ Observe the maximum permissible pres-
sure (see chapter „Installation / Specifi-
cation / Data table").
◦ The specific water resistivity of the
mains water supply must not be under-
shot (see chapter „Installation / Specifi-
cation / Data table").
◦ Drain the appliance as described in
chapter „Installation / Maintenance /
Draining the appliance".

Special information

27